NEED MACRO TO GO TO LABEL AFTER USE A SQM - Printable Version +- BBot - The best bot of the world (https://forums.bmega.net) +-- Forum: Scripts & Macros (https://forums.bmega.net/forum-4.html) +--- Forum: Requests (https://forums.bmega.net/forum-17.html) +--- Thread: NEED MACRO TO GO TO LABEL AFTER USE A SQM (/thread-19244.html) |
NEED MACRO TO GO TO LABEL AFTER USE A SQM - toty1234 - 01-29-2016 After use X SQM, go to label Y... Because i'm using this macro to use the sqm Quote:Map.Use(17238, 33029, 32140, 7, 1) But, after use the sqm, the script comes back to the previous point, i need to after bot uses that SQM (ID 17238)(COORD 33029, 32140, 7), goes to label SUB, or only continue the script normally... Thanks! RE: NEED MACRO TO GO TO LABEL AFTER USE A SQM - Catar - 01-29-2016 Change 1 to 0 RE: NEED MACRO TO GO TO LABEL AFTER USE A SQM - toty1234 - 01-29-2016 (01-29-2016, 07:40 AM)Catar Wrote: Change 1 to 0 Continue the same problem, the char goes up again... RE: NEED MACRO TO GO TO LABEL AFTER USE A SQM - kaiquegabriel - 01-29-2016 Code: Map.Use(17238, 33029, 32140, 7, 1) Label(SUB) RE: NEED MACRO TO GO TO LABEL AFTER USE A SQM - damiansnk - 01-29-2016 If id is changing after use so try by maptool Did u added fixed point before macro ? Does macro is manual not automatic ? Does next point is in range less than 6 sqm ? Or problem perhaps is in bugged macro. Check exactly is and location. If is only 1 item with id what u wanna use try do with X:=self.position x And in x loc put !x! RE: NEED MACRO TO GO TO LABEL AFTER USE A SQM - toty1234 - 01-29-2016 For now i have "soluctioned" part of this problem, but now, with simple fixed points, the cavebot continue stucking, and going back to up grounds... Resume... I dont need this initial macro, but in a simple fixed point, the script is bugging, and going back 2 points... RE: NEED MACRO TO GO TO LABEL AFTER USE A SQM - toty1234 - 01-29-2016 Solved! I used the macro Self.MoveS() And now, the script continues running normally... |