04-12-2012, 06:53 PM
Sorry for posting another post under my previous one, but I found a solution and I think it should be here and not up there as edit.
After another few hours of attempts here it goes:
I am aware that this problem does not occur on every ladder, but it does in this particular place where there are rocks and drawbridges, probably because of reading them wrongly by a cavebot.
I hope this will be helpful to someone in the future.
Successful video:
After another few hours of attempts here it goes:
Quote:1. Do not use "Learn" function while getting down/up ladders.
2. Create a "Fixed point" next to the "ladder hole" SQM.
3. On the same SQM as "Fixed point" add "Delay" of 1 second (without this it wont work)
4. One the same SQM as "Fixed point" and "Delay" add "Macro" (Codes/Labels -> Macro) to get down: 200 {moveW} Self.MoveW) — remember to change Self.MoveW to desired direction.
5. Create one point down the ladder (does not have to be exactly on ladders sqm 3x3 area is enough).
6. Create next point up the ladder. (does not have to be exactly on ladders sqm, 3x3 area is enough).
I am aware that this problem does not occur on every ladder, but it does in this particular place where there are rocks and drawbridges, probably because of reading them wrongly by a cavebot.
I hope this will be helpful to someone in the future.
Successful video: